|
Bosch GL2.5 Ariston 2-1/2-Gallon Point-of-Use Indoor Electric Mini-Tank Water Heater | 
 enlarge
| Brand: Bosch
Category: Home Improvement
List Price: $188.00
Buy New: $149.00
You Save: $39.00 (21%)
New (15) from $149.00
Rating:  10 reviews
Media: Tools & Hardware
Shipping Weight (lbs): 22
Dimensions (in): 10.5 x 14 x 14
MPN: GL2.5
Model: GL2.5
UPC: 052575600109
EAN: 0052575600109
Shipping: Eligible for Super Saver Shipping
Availability: Usually ships in 24 hours
| |
| Features:
| • | Stores up to 2.5 gallons of water to supply hot water for a single sink | | • | Easy, space-saving installation and draws power from standard outlet | | • | Works independently or in line with a larger water-heating system | | • | Glass-lined tank for longer life | | • | Dimensions: 14-by-14 by-10-1/4-inches; Weight: 16 pounds; Electrical: 120 volts, 1500 watts |
|
| Similar Items:
|
| Customer Reviews: Read 5 more reviews...
 Could Be Better November 19, 2008
Mary Bixby (California)
The heater is working fine, but it could have a faster recovery period. Hot water, really hot water is not immediately available all the time. The thing we like best is that we are no longer running a gallon and a half of water down the drain or into empty milk containers before hot water comes to the kitchen tap. We live in the California desert and water is very precious.
 Installed in small church November 16, 2008
J. Burkholder
We purchased this water heater to install in our small church to comply with city code (hot water must be available at bathroom sink). It was easy to install. It heats water very quickly. We tried to regulate the hot water temperature to 110 degrees F, but this seemed not possible. The water was either 100 or 120 degrees (factory set). So we returned the thermostat to the factory pre-set and turn the water heater off when no hot water is necessary.
Great little hot water heater September 22, 2008
Ronald Oberley (Mora, NM)
3 out of 3 found this review helpful
We had a small reem hot water heater for under the sink that lasted 4 years. This one was easier to install and heats water faster and takes up less room (both were 2 1/2 gal). It stays cooler under the sink (it's enclosed) than the reem.
Handy heater May 8, 2008
John Wolever (Camp Verde, AZ United States)
4 out of 5 found this review helpful
Having instant hot water at the kitchen sink is wonderful. This was intended as exact replacement for unit that began leaking after about 2 and a half years. I have hard water (about 700 ppm) and did not follow the instructions about periodic dismantling and cleaning. The heating element accumulated a lot of scale and finally split apart and caused a leak at the base where the electrode mounts. The leak was very gradual and was not noticed until much absorbsion occured on flooring beneath the kitchen sink and mold appeared. Rather than attempting to clean the tank and replace the effected parts, I ordered a new unit. It turns out the new unit was slightly different in physical size. It was 1/2 inch wider and an inch higher requiring modifications to my under sink arrangement (R/O filter ect). I plan to clean the tank and replace the heating element in about a year, hopfully avoiding complications.
Installation ideas May 6, 2008
B. Breckenfeld (Carrollton, TX)
7 out of 8 found this review helpful
Great little water heater. The outside plastic case doesn't even get warm on the highest setting; really well insultated. Some changes I made:
- Used a different 110v circuit to avoid overloading dishwasher or disposer circuit. The nearby disposer outlet was switched and not usable for this anyway.
- At first I plumbed the garage water heater as input to this little one, but realized that would just keep wasting the energy used to heat the long line of water that arrives cool anyway. So I plumbed the cold water to the input side of the 2.5 gal unit and it still works just fine. We just have to avoid running too much hot water unnecessarily like we did previously waiting for the hot water to arrive.
- (While doing this replumbing, I also moved my dishwasher line from the hot to the cold water side since it has it's own water heater element. This means the garage hot water heater no longer supplies any hot water to this sink location. I figure this somewhat offsets the added energy use of the little one.)
- I drilled holes in the covers of the Ariston to put a knob on the thermostat shaft. This allows us to dial in the lowest setting that will provide sufficient hot water for normal use. The highest setting is very hot, and can easily hurt your fingers unless you cut it with cold water.
- Might be a good idea to put a low metal tray under the unit which is a code requirement in my town for standard water heaters.
- I'm considering adding a timer to turn off overnight and when we are away; need a heavy duty one with high wattage capacity.
|
|
|
Thanks for shopping with us! | |
