|
Speedway Series 7117 125 Amp 110 Volt Single Phase Wire Feed Flux Welder |  | Brand: Speedway
Category: Home Improvement
This item is no longer available
Rating:  8 reviews
Media: Tools & Hardware
Size: 125 Amp
Shipping Weight (lbs): 32
Dimensions (in): 15 x 8 x 13
MPN: 7117
Model: FW125A
UPC: 093184071171
EAN: 0093184071171
| |
| Features:
| • | Self regulating feed control | | • | Thermal protection with warning light | | • | Input: 110volt, single phase | | • | Wire capacity: 0.035" or 0.030" | | • | No Gas Needed |
|
| Similar Items:
| |
| Editorial Reviews:
Product Description
This flux core welder handles .023, .030 and .035in. wires and welds 18-gauge to 3/16in. steel. Self-regulating feed control; wire feed speed 0-400 IPM. Duty cycle: 10% @ 90 Amp, 19V; thermal protection with warning light.
|
| Customer Reviews:
Showing reviews 1-5 of 8
 welder October 27, 2009
Bernice L. Kropf
My son and daughter love this welder. He sold his huge one so he could enjoy something easier to handle, use, carry, and work with. This one gives him a lot of pleasure! I am so glad we found it online!
 so far so good October 16, 2009
crrowe (detroit)
first unit the motor didnt run to feed the wire through but they replaced it quick and were very helpful on the phone. after i got the second unit i set it up right away and tested the motor it ran fine. i used it on steel today and i think if i wasnt new to welding it would be great in other words any problem at this point is due to the user.
Speedway is a good Way September 13, 2009
BIG "UN" Davidson (Alabama)
1 out of 1 found this review helpful
I'm 54 yrs old and have been welding since 1973.This little welder surprised me it is very well made and easy to operate /is great to teach with and it will melt 3/16 steel if you don't keep it moving.Have not really tried the low side yet on anything thin but I have no doubt that it will be fine.I have ran 6 rolls of.35 wire so far and I have found it best to take tip out during spool change so it don't cobble up at spool.Both of my local hardware stores carry the spool I use it is a 2pound 5/8 hole that this welder uses and tips are also easy to get a 10 pack is about $5. Seems to have slight problem finding hole in tip/goes through liner fine but when it gets to tip?? If you run high side you can weld about 7 to 8 minutes before heat light comes on and shuts you down but thats a long weld.And by the time you check what your doing grab a drink of what ever its ready to go again.
 speedway welder August 14, 2009
Steven R. Schultz (st joseph mo)
Wire feed mechanism quit working within the first five minutes.. I returned the unit it for refund.
Not working out of the box!! August 14, 2009
C. Byrne
The only plus is the item was shipped quickly. Although it doesn't help when this did not even work out of the box! I sent it back for a refund.
Showing reviews 1-5 of 8
|
|
|
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED ‘AS IS’ AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME. Thanks for shopping with us! | |
